Isy- - Descrizione in italiano Cisco Rs-232 Cable Dce Female To Smart Serial 10 Feet

Marche

Marchi Principali Distribuiti

Categorie

Scegli solo i prodotti...

Last Week (1.432) Novità (12.080) Consegna Immediata (265) Disponibili Magazzino (106.370) in Promo(652) al Costo(18)

Tutti i Costi Finanziari sono esposti trasparentemente.

Tutti i prezzi NON sono comprensivi di IVA.

SCHEDA PRODOTTO

PartNumber: CAB-SS-232FC	Cisco Rs-232 Cable Dce Female To Smart Serial 10 Feet	No Login .... No Prezzo

		Pagamento e Prezzo si cambiano nel Carrello, inserito il primo articolo.

	Marchio:Cisco
	Codice:108116.01
	PartNumber:CAB-SS-232FC
	EAN:0746320089928
	Ordinabile
	Notifica Disponibilità




	Altri articoli del Produttore: Cisco
	Altri articoli nelle Categorie:/ Hardware / Sistemi Server / Accessori

HOW SURGE EVENTS HAPPEN In a normal equipment environment there are reasonable threats from Electrostatic Discharge (ESD) and lightning transients which can cause loss of data integrity and permanent damage to equipment if not controlled. ESD threats are generated by personnel movement, which causes triboelectric (rubbing causing a separation of charge) charges to accumulate on equipment or clothing and then be discharged through hand or tool "touch". This discharge can represent several thousand volts at 10 to 30 amps of current. There are two primary threats from an ESD event. These are the peak current of the discharge and the resulting electromagnetic field. Should the input to the device not be protected from this ESD threat, as little as 100 milli-Joules can cause permanent failure to an input device at the silicon die level. Lightning also can create a large disturbance and delivery destructive energy to the equipment. These lightning events cause differential voltages to develop as a result of inductance in the protective earth ground path to the equipment. During a direct lightning strike it is possible to measure peak currents into the Kilo Amp range. These events can occur both at the facility as well as outside the facility along utility power lines. When they occur on the power line outside of the facility peak currents can be extended in time due to the additional inductance of the power line. A normal event may be 10 usec zero to peak, with a decay of 200 usec. These currents are called longitudinal. The Cisco surge protection cable will adequately prevent this transient damage from occurring to within the industry standards for lightning protection devices. A good equipment chassis protective ground is strongly recommended to assure adequate protection. EFT disturbances occur as a result of arcing contacts in electro-mechanical switches and relays commonly found in an industrial environment. The electro-mechanical switches are used to connect and disconnect inductive loads. Like ESD, EFT can be especially fatal on data and I/O lines. The fast rise time of the EFT pulses demand similar protection as ESD pulses. CONFIGURATIONS THAT ARE SUBJECT TO SURGE EVENTS There are several hardware configurations and applications that are more subject to damage from ESD events. These configurations include the following: - Locations Subject to Electrical Storms-Any location where electrical storms are common is a good candidate site for surge protection on the serial ports; - Unshielded Cables-If unshielded cables are used to connect to the serial port, it is much more likely that electrical discharges will be picked up by the cabling and damage the serial port; - Long Cable Runs-The longer the cable, the more susceptible it is to surge events, even if the cable is shielded; - Outside Wiring-If the cable runs outdoors, it is more susceptible to surge events; - Different Earth Grounds-If the router and the device at the other end of the serial cable are connected to different earth grounds, then the cable can become a conduit for current that equalizes different ground potentials; - Installations with Multiple Serial Port Failures-If an installation has experienced multiple serial port failures in the past, it is a good candidate for surge protection;

	Confezione:
	Peso Lordo: 10 Kg Dimensioni Lorde: 100x100x100 mm

	Cisco - Sito web:http://www.cisco.com

Tutti i prezzi NON sono comprensivi di IVA. Il Listino è in EURO, salvo se diversamente indicato. Marchi e i nomi di prodotti sono registrati dai rispettivi titolari. Dati a cura del Fornitore. Non possiamo essere ritenuti responsabili per eventuali errori o refusi presenti. Prodotti, versioni, prezzi, termini e garanzie sono soggetti a cambiamenti senza preavviso. In ogni rapporto di fornitura valgono le Condizioni Generali di Vendita. Prezzi aggiornati in tempo reale.

Perchè Comprare qui?
	Prodotti di qualità dei maggiori Marchi
	Informazione sulla disponibilità dei prodotti
	Aiuto all'acquisto
	Servizi EDI e di trasferimento Dati Elettronici
	Pagamenti sicuri con transazioni riservate
	Rispetto della Privacy
	Trasparenza sui costi di trasporto
	Supporto nella soluzione di problemi
	Professionalità e competenza dello Staff
	Ricerca su richiesta di prodotti non a Listino

Info	Help	Area Clienti
Contattaci ISO Comunicazioni Azienda Tecnologie Marchi Distribuiti Privacy	Perche' registrarsi? Servizi EDI ai Clienti Prodotti Difettosi Colli Mancanti o Danneggiati Garanzia Sicurezza Pagamenti	Gestione News Letter Richiedi RMA Stato di un RMA Dati Fatturazione Dati Destinazione Condizioni di Vendita